The ALL SIGN SYSTEMS provides a range of fasteners normally supplied with brackets and clips. Under no circumstances should hex head bolts be used in channel extrusions.ALL SIGN SYSTEMS bolts have an ultimate tensile strength of 70N/mm2 and should be tightened up to a maximum torque load of 25Nm using a calibrated torque wrench. Failure to correctly torque up bolts on brackets and clips is the single most common cause of sign installation failure. It is recommended, before fitting, that all bolts are lightly oiled to avoid binding when tightening nuts. Washers should always be fitted under the M8 nut; this strengthens the bracket when fully tensioned. Torque Settings for Bolts Maximum: 25Nm Recommended: 22Nm Minimum: 20Nm
$316.25
The ALL SIGN SYSTEMS provides a range of fasteners normally supplied with brackets and clips. Under no circumstances should hex head bolts be used in channel extrusions.ALL SIGN SYSTEMS bolts have an ultimate tensile strength of 70N/mm2 and should be tightened up to a maximum torque load of 25Nm using a calibrated torque wrench. Failure to correctly torque up bolts on brackets and clips is the single most common cause of sign installation failure. It is recommended, before fitting, that all bolts are lightly oiled to avoid binding when tightening nuts. Washers should always be fitted under the M8 nut; this strengthens the bracket when fully tensioned. Torque Settings for Bolts Maximum: 25Nm Recommended: 22Nm Minimum: 20Nm
$316.25
The ALL SIGN SYSTEMS provides a range of fasteners normally supplied with brackets and clips. Under no circumstances should hex head bolts be used in channel extrusions.ALL SIGN SYSTEMS bolts have an ultimate tensile strength of 70N/mm2 and should be tightened up to a maximum torque load of 25Nm using a calibrated torque wrench. Failure to correctly torque up bolts on brackets and clips is the single most common cause of sign installation failure. It is recommended, before fitting, that all bolts are lightly oiled to avoid binding when tightening nuts. Washers should always be fitted under the M8 nut; this strengthens the bracket when fully tensioned. Torque Settings for Bolts Maximum: 25Nm Recommended: 22Nm Minimum: 20Nm
$316.25